SELECT Machine LC-150VS

The LC-150VS Mill features a Variable Speed Head, Digital Readout System, power feeds for table, saddle, and knee, Power Drawbar, Automatic Lubrication, and Work Lamp. ISO 9002 certified, it uses Meehanite casting, ABEC-7 bearings for spindle support, and a chromed, ground quill. The motor shaft and pulleys are balanced and chromed with an oil channel.

It includes a roller bearing for shaft support, preventing belt tension distortion, a one-shot lubrication system, and hand-scraped saddle and knee. A double nut design controls backlash, with pre-loaded thrust bearings, a patented knuckle design, and hard chrome dovetail ways for durability and precision.

Table Size		50” x 9”
Travel:
X		38”
Y		12”
Knee		16”
Maximum Quill Travel		5”
Quill Diameter		3-3/8”
Spindle Taper		R8
Spindle Speed Range		60 – 4500 RPM
Quill Feeds Per Revolution In Auto Feed		0.0015”, 0.003”. 0.005”
Spindle Motor		3 Hp
Power Requirement		220V or 440V/ 3 Phase
Machine Weight		2,500 lbs.
Floor Space		7’W x 6.5’D x 6.75H

AVAILABLE OPTIONS:

Digital Readout System
Table, Saddle, and Knee Powerfeed
Power Drawbar
Automatic Lubrication
Work Lamp

ISO 9002 Certified:

Quality Up To World Industry Standards.

Meehanite Casting:

Highest Grade Of Casting Possible.

A Pair Of High Out-Put Fans:

Keeps Head And 3-Hp Motor Cool, To Run Jobs For Extended Periods Without Damaging The Motor, Belts And Bearing.

A Pair Of Precision ABEC-7 Angular Contact Bearings To Support Spindle. The Quill Is Ground And Chromed To Fit The Housing:

This Insures A Spindle Runout Of .0002” T.I.R.

Motor Shaft And Varidrive Pulleys Are Dynamically Balanced, Then Chromed For A Flawless Fit, Ground Ribs On Inside Diameter:

For Smooth Speed Changes.

Motor Shaft Has An Oil Channel In The Center That Is Fed By A Grease Fitting On The Lower End:

To Keep Vari-Drive Pulley Moving Smoothly On The Shaft.

The LC-150VS Mill Uses A Roller Bearing For The Lower Support Of The Shaft: It Ensures Proper Loading, Support And Alignment It Also Prevents The Shaft From Being Distorted By The Tension Of The Belt:

For Quiet, Accurate Operation At Any Speed For Years And Years.

One Shot Lubrication System:

For Lubrication Of Ways And Lead Screws. (X,Y And Z-Axis)

Hand Scraped Saddle And Knee:

For Better Oil Retention. It Avoids Having Chips And Dirt Embed In The Knee And Damage The Sliding Surface.

Oil Groove Are Milled:

For Maximum Lubrication On All Wear Areas.

Table And Saddle Backlash Is Controlled By Double Nut Design:

Keeps Lead Screw In Contact With Bronze Nuts An All Times To Keep Backlash At .0008” Within 20”.

Table And Saddle Are Mounted With Thrust Bearings That Are Pre Loaded:

Eliminating Endplay For Precisely Controlled Lateral Movement.

Patient Knuckle Design Uses 6 Bolt 3 Per Side, Securing Them From The Outside:

This Method Locks The Head Securely Resulting In Better Accuracy And Performance.

Ways Are Hard Chrome Dovetail On Saddle And Column.